Ceramic

Prepare ceramic pills

 

Blanching is one of the daily work done in the refining plant in the industrial factories of Niramik which produces goods by making slips. Bronzing is the name given to the combination of pill and glaze ingredients by Rahar in a balanced way. In other words, the process of mixing the ingredients of pills and glaze in a balanced way by the brewer is called dyeing.

 

The blazer is a special silicone container. It has a shaft in the center with paddles, braces, knives, and propellers. The shaft is rotated by an electric motor. Rangers are usually made of concrete. It is built on or below the factory floor. There is a slight difference between the king built in earlier days and the modern-day blanche. The old ranger has large paddle gates that ignite the snip all over the pot and the speed of such a ranger is 15 r. P. This happens so far. And modern Blanzer propellers are relatively small and have an average of 150 to 300 Rs. P. M. Happens. This results in almost the same speed of the whole mixture. The process of moving and mixing the slip of modern day Punjab is better than that of the old gate type king. It can also be driven into sediment-wearing slips and is available in very fast homogeneous mixtures. But the old bronzer has to be kept in constant motion. Because once the sediment is in it, it is not possible to run it again without removing it.

 

There are some blankets of a slightly different nature than the rangers mentioned earlier. The nature of their formation is the former. Like. However, it has many wooden vertical paddles with the central shaft. To get a homogeneous mixture of solid material and water, they need about 100 Rs. P. M. Is rotated at speed. Many plants prefer two-cylinder rangers. Its shafts are rotated in two opposite directions. If you charge the material manually in such a king, 4 to 6 batches can be completed daily.

 

The king is first charged with the required amount of water. Clay is then charged. If it is in the shape of a lump, its size should not be more than 3 inches wide. After breaking the lamp by coloring clay and other plastic materials, non-plastic material is added to it. Since it is not possible to grind non-plastic material in the blancer, they have to be taken before charging the blazer.

 

The amount of time required for dyeing depends on the properties of K and other ingredients. It takes 4 to 6 hours to break the lamps and make a homogeneous mixture of slip.

 

The slip was quickly removed from the blancher after the ranching was stopped. This is because non-plastic materials quickly accumulate in the form of sediment under the blanket, creating a solid layer that is very difficult to remove.

 

After the blazing is done, the snip is passed through the screen. This removes unwanted material along with the slip. Ball clay in particular contains a considerable amount of lignite and other elements that can be easily removed by a screen.